すべてのカテゴリ

The clock crystal and associated circuits should be placed in the center of the PCB and should have a good ground plane, not close to the I/O interface. Clock generation circuits are not allowed in the form of daughter cards or daughter boards, and must be fabricated on separate clock boards or load-bearing boards. Only the equipment related to the clock circuit is installed in the PCB clock circuit area of ​​FS TECH, avoid installing other circuits. Other signal lines should not be routed near or below the crystal: Clock circuits and ground planes are used under the crystal if other signals pass through the plane violating the image plane function. If the signal passes through the ground pl

The reason PCBs are called single-sided is because the simplest PCBs have parts on one side and wires on the other. This is because the wires only appear on one side. Multilayer boards with multiple layers of conductors require proper circuit connections between the two layers. The bridge between the chains is called a viaduct. The basic PCB design process of FS technology can be divided into four steps:(1) FS Technology Schematic Design: Schematic design mainly uses Protel DXP schematic editor for circuit design. Circuit Board Manufacturing and Assemblywww.atoallinks.com/2022/optical-fiducial-pcb-design-fs-technology/ (2) Network report generation: An online report is a report showing the c

PCB copy board means copying other people's circuit boards, which is very important for a small company and can save a lot of costs. Next, FS Technology will explain the steps to youFS Technology PCB Copy Board Step 1: Find the circuit board . First write down the model numbers, parameters and locations of all components on a piece of paper, especially the addresses of diodes and transistors and the notch addresses of the IC. These two assembly locations are best photographed with a digital camera, many PCBs are getting more advanced. And some of the diodes and transistors above are not visible at all. what is a pcb-FS Technology Copy board PCB step 2: disassemble components Take all compone